Part No. 103675 Rev. C/W10159564Built-In Refrigerator42 and 48 Inch Models: EF42DBSS, EF42NBSS, EF48DBSS, EF48NBSS IF42DBOL, IF42NBOL, IF48DBO
8Backer PanelOverlay PanelSpacer Panel1/4" (6.35 mm)3/4" (1.9 cm)1" (2.5 cm)1/2" (1.3 cm)1"11/4"11/2"1"(2.5 cm
91/4" (6.35 mm)3/4" (1.9 cm)1" (2.5 cm)1/2" (1.3 cm)3/4"1"11/4"11/2"1/2"RefrigeratorSide TrimHinge90° Doo
10Installation RequirementsCustom overlay panels used with models IF42 and IF48 allow you to blend the exterior of your refrigerator into the overall
11Installation RequirementsCustom HandlesDacor recommends handles with larger D-style pulls. If using screws with thick heads, they must be countersun
12Custom Side Panels - EF42/EF48Custom side panels may be needed when not enough space is available to have cabinets on both sides of the refrigerator
13Unpack the RefrigeratorIMPORTANT:Do not remove the protective film until the refrigerator is in its operating position.All four leveling legs must
14Installation InstructionsInstall Anti-Tip BoardsIMPORTANT:To avoid tipping during use, the solid soffit must be within 1” (2.5 cm) maximum above t
15Installation InstructionsUsing a cordless drill, drill a ¼” (6.35 mm) hole in the cold 5. water pipe you have selected.Fasten the shutoff valve to t
16Continue adjusting all of the leveling legs to raise the 3. refrigerator until the top is within at least 1” (2.54 cm) of the top soffit.NOTE: If an
17IMPORTANT:Install the custom handles prior to installing the panels on the refrigerator. Create custom door overlay panels according to the spec
© 2008 Dacor, all rights reserved.All specifications subject to change without notice.Dacor assumes no liability for changes to specifications.Refrige
18After adjusting, check the doors to make sure they are even at 4. the top and bottom. If the doors are not even, continue to turn the bushing to adj
19Snap the skirt onto the base grille.3. Trim the skirt by scoring the 4. proper “V” groove with a utility knife. Break the skirt at the score line.Us
20Complete InstallationTurn the water supply line valve to the “Open” position.1. Turn the refrigerator switch to the ON position. See 2. Power On/Of
Dacor ● 1440 Bridge Gate Drive, Diamond Bar, CA 91765 ● Tel: (800) 793-0093 ● FAX: (626) 403-3130 ● www.Dacor.com
1Refrigerator SafetyWARNINGTip Over HazardRefrigerator is top heavy and tips easily when not completely installed. Keep doors taped closed until refri
2Refrigerators With Ice and Water DispensersRefrigerators Without Ice and Water DispensersModel IdentificationEF42DBSS and EF48DBSS:42” and 48” disp
3Location RequirementsYour Dacor refrigerator can be recessed in an opening between cabinets or installed at the end of a cabinet run using a side pan
4Electrical RequirementsBefore you move your refrigerator into its final location, it is important to make sure you have the proper electrical connect
5Installation RequirementsIf the water pressure to the reverse osmosis system is less than 40 to 60 psi (276 to 414 kPa):Check to see whether the sedi
6Product DimensionsSide View:The depth from the front of the top grille to the back of the refrigerator cabinet is 25³⁄8” (64.5 cm). The power cord
7Door Swing DimensionsThe location must permit both doors to open to a minimum of 90°. Allow 4½” (11.4 cm) minimum space between the side of the refri
Kommentare zu diesen Handbüchern