Dacor HGER30SLP Installationsanleitung Seite 1

Installation InstructionsPart No. 113713 Rev. ATHIS APPLIANCE WAS TESTED ACCORDING TO THE LATEST EDITIONS OF ANSI Z21.1 AND CSA 1.1, STANDARDS FOR HO

8Preparing for Installation WARNINGIf the home utilities do not meet product specifications, postpone installation. Call the dealer, the gas supplier,

9SCREW-SIZE TABLESub-Floor Type/Floor Covering Thickness Screw SizeConcrete or wood sub-floor, no floor covering#8 x 1*Concrete or wood sub-floor, flo

10Removing the Oven Door WARNING• With the door off the range, do not remove the hinge catches. The springs could release abruptly, causing personal

11Final Installation1. Peel all protective plastic from the range.2. Measure from floor to countertop, and adjust the leveling legs so the cooktop i

12SimmerSear Burner Assembly (left-front burner only)Standard Burner Assembly (left-rear, right-rear, right-front burners)STEP 1: Install burner head.

13Verifying Proper OperationBefore operating the range, read the User Manual completely. It contains important safety, service, and warranty informati

Dacor ● 14425 Clark Avenue, City of Industry, CA 91745 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www.dacor.com

Table of ContentsIMPORTANT• Installer: For safety’s sake and to minimize problems, read this manual thoroughly before beginning the installation. Lea

1Important Info About Safety InstructionsThis manual cannot cover every possible problem and situation that can occur. Use common sense and caution wh

2Important Safety Instructions WARNING• Read the User Manual before operating the range.• Keep packaging away from children. Plastic sheets and bags

3Consignes de Sécurité ImportantesInformations importantes sur les consignes de sécuritéCe manuel ne peut pas couvrir tous les problèmes et situations

4Consignes de Sécurité Importantes ATTENTION• Lisez le manuel d’utilisation ci-joint avant d’utiliser la cuisinière.• Gardez les matériaux d’emballa

5Electrical Requirements WARNING• Observe all codes and ordinances during planning and installation. Contact the local building department for detail

6Product tolerances: ±1/16” (±1.6 mm)Product DimensionsWidth: Range Installed In Cabinetry Cutout Range Installed In Cutout With Downdr

7Note 2FG2 Cabinet/countertop depth is at discretion of customer but cabinet face MUST NOT protrude further than rear of front panel, see product dime