Dacor Dishwasher Wartungshandbuch Seite 9

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 34
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 8
Page 3-2
seCTion 3 - CyCle, sysTeMs & CoMPonenTs
Component Function Test (continued)
Entering the Water/Service Test
From Power Failure
While the control displays power failure or flashing lights, press and hold the Short wash and the Rinse
& Hold pads simultaneously for one second. The dishwasher will start through the test cycle.
From Idle
With no cycle selected and the dishwasher sitting idle, press and hold the Hi-temp and the Start pads
simultaneously for one second. The dishwasher will start through the test cycle.
The chart below shows the complete Water/Service Test cycle. To manually move to the next phase
of the cycle press the Start pad. If at any time the door is opened the test cycle will end and flashing
lights will come on showing power failure. The Sanitize LED will light at the end of test to check the
LED. If the rinse aid dispenser is empty, the display will read LO to indicate the contact in the dispenser
is closed.
Water Temperature Test Mode
This test is for testing the thermistor in the sump as well as the control.
Start a Normal wash cycle and allow the dishwasher to fill and wash for two minutes at which time,
press the Start/Cancel pad twice (2). This will stop the dishwasher and send it to idle.
With the dishwasher in idle press and hold the Normal wash and the Start/Cancel pads
simultaneously will start the test. The test will show a two digit display for the temperature of the
water (from 0°F to 99°F). If the water temperature is over 99°F a decimal point will be displayed
to show 100°F, then the added degrees over. This reading will be updated every three seconds until
the Start/Cancel pad is depressed to stop the test.
1.
2.
Step
Description
Time
Water Valve
Wash Motor
Drain Pump
Heater
Dispenser
Fan
Sensing LED
Drying LED
Sanitized LED
Dispenser Low LED
Clean LED
1 Fill / Dispenser
3 Wash / Heat
4 Pause
5 Wash / Heat
6 Wash / Heat / Dispenser
7 Drain
Completion
* Dynamic fill - water valve is open until pressure switch is closed
2 Fill / Dispenser / Wash
8 Dry
59
1 0 0 0 0 0 1 0 0 0 0
21
1 0 0 1 0 1 0 0 0 0
*
45
0 1 0 1 0 0 1 0 0 0 0
0.6
0 0 0 0 0 1 0 0 0 0 0
75
0 1 0 1 0 0 0 0 0 0 0
80 0 1 0 1 1 0 0 0 0 0 0
90
0 0 1 0 0 0 0 0 0 0 0
90
0 0 0 1 0 1 0 1 0 0 0
460.6
1 0/1 1
Seitenansicht 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 33 34

Kommentare zu diesen Handbüchern

Keine Kommentare