Dacor CM24P-1 Anleitung zur Fehlerbehebung Seite 24

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 33
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 23
Programming Mode:
NOTE: The Program Code is located on the Serial Plate after the word Code.
1. Press and hold the WATER Keypad.
2. Press and hold LL Keypad.
3. Release the WATER Keypad and wait 3 seconds.
4. The control will display PE to indicate the programming mode.
5. Entry is confirmed by pressing the LL Keypad once more.
6. The control will display the current Program CODE. This value should be validated with the Program CODE printed on the unit
serial plate. NOTE: If the Program CODE is correct, the Programming Mode is exited by pressing water Keypad for 3 seconds.
7. Press the UR Keypad or LR Keypad to change the digit value with each key press.
8. The decimal point indicates the selected digit. Press the UL Keypad to select the next digit.
9. Once the desired Program CODE is entered, press and hold the LL Keypad until the Program CODE begins flashing indicating it
has been saved.
NOTE: If you attempt to enter an invalid Program CODE the control will not save the new code, but will beep. (The unit will NOT run with a
Program CODE of 0000). Once the Program CODE has been saved the Programming Mode is exited by pressing any key or by opening or closing
the refrigerator door. If the new code is incorrect this process should be repeated.
Forced Defrost Mode:
Enter the Forced Defrost Mode by performing the following sequence of events:
1. Press and hold the WATER Keypad.
2. Press and hold LR Keypad.
3. Release the WATER Keypad and wait 3 seconds. Fd appears in the left side of the display.
4. Press the LR Keypad again. Sh appears in right side of the display.
5. Press LR again to force defrost Fd and Sh will flash in display indicating unit is in defrost.
Service Test Mode:
Enter the Service Test Mode by performing the following sequence of events:
1. Press and hold the WATER Keypad.
2. Press and hold UR Keypad.
3. Release the WATER switch and wait 3 seconds.
4. The display will show SE confirming entry in the Service Mode.
5. Press the UR Keypad again to confirm entry in the Service Mode.
6. Display will show 101 in left display and numeric or dashes in right display.
7. Press UL Keypad and LL Keypad to toggle through Service Test numbers.
8. To exit service test mode, open and close refrigerator door or hold door alarm for 3 seconds.
Service Test - 101 Defrost Heater & Defrost Circuit
• Press the UR keypad or LR keypad to energize or de-energize the Defrost circuit. The display will read OFF when de-energized, OP when
energized with open defrost thermostat and CL when energized with closed defrost thermostat.
Service Test - 102 Compressor / Condenser Fan
• Press the UR keypad or LR keypad to toggle Compressor/Condenser fan On and Off.
Service Test - 112 Freezer Fan
• Press the UR keypad or LR keypad to toggle Freezer Fan On High speed, Low speed and Off. NOTE: Display will show state 0.0 for OFF, 11.0-
14.0 volts for High speed or 7.75- 8.25 volts for Low speed.
Service Test - 113 Ice Compartment Fan
• Press the UR keypad or LR keypad to toggle Ice compartment Fan On High speed, Low speed and Off. NOTE: Display will show 0.0 for OFF,
11.0-14.0 volts for High speed or 7.75- 8.25 volts for Low speed.
Service Test - 121 Damper Operation
• Press the UR keypad or LR keypad to toggle Damper OP open and CL closed. NOTE: When damper is opening or closing it will display -- if
damper state is unknown. It can also show DP if damper is moving when initially entering service mode.
Service Test - 131 Mullion Heater
• Press the UR Keypad or LR Keypad to toggle Mullion Heater Off and On.
Service Test - 141 Fresh Food Thermistor
• Will Show Fresh Food Temperature or OP for open thermistor or SH for shorted thermistor.
Service Test - 142 Freezer Thermistor
• Will Show Freezer Temperature or OP for open thermistor or SH for shorted thermistor.
Service Test - 144 Ambient Thermistor
• Will Show Ambient Temperature or, OP open thermistor or SH shorted thermistor.
Service Test - 145 Ice Box Thermistor
• Will Show Ice Box Temperature or, OP open thermistor or SH shorted thermistor.
Dacor 36” Water/Ice Dispenser Freestanding Refrigerator - Programming and Diagnostics:
Model: EF36IWFSS
PG: 24
Control Panel Touch Pads
Seitenansicht 23
1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 32 33

Kommentare zu diesen Handbüchern

Keine Kommentare